change the date format in ham radio deluxe

#Change the date format in ham radio deluxe install

Macros can be accessed from either a toolbar located between the Receive Pane and the Transmit Pane of DM-780 or from a macro pane which can be pinned to the display. You can just load them from the external folder and save them back into the DM-780 program folder. In the event you have to re-install HRD from scratch, having the macro sets saved in an external folder will eliminate the need to re-create the sets. When you create a custom set of macros it’s recommended that you not only save the set within the DM-780 directory but also in an external directory, such as in a folder in your Documents.

The uses for macros are almost unlimited. Sets can be made mode specific for CW, PSK, RTTY or set up for contesting exchanges. This is usually a READ ONLY file and should be kept as a template to build other editable sets. When installing DM-780 for the first time you will find a default set of macro definitions. It’s much more convenient to just click on a macro to send a CQ call rather than type in the call each time.ĭM-780 contains a Macro Manager tool that allows you to set up and maintain an unlimited number of macro sets to handle these procedures. They allow you to pre-define operating procedures and execute them with just a click of the mouse. Macros are a great way to handle repetitive operations in the digital modes. I can't emphasize that enough.Solution home Ham Radio Deluxe User Guides Digital Master (DM-780) Macro Manager IF IT'S NOT SET CORRECTLY YOU COULD DAMAGE YOUR SDR. It seems to work quite well but be careful, watch your settings, and read the instructions pertinent to this. This provides a pretty effective rapid attenuation of your SDR so you don't damage it while transmitting. Set Mute For to 50 ms and Restore to 25 ms.Enable Auto Mute, make sure peak is disabled, enable Mean by chicking in the box, set it at about -40 dB.You should see an option for Auto Mute on the left of the Options window.To do so find any of the option buttons in SDR Console and click on it, then choose Show all Options. Assuming you are using an SDR and a different receive antenna it is almost imperative that you attenuate the SDR when you transmit.If you did everything right SDR Console and HRD Rig Control should sync and you should be able to change the frequency of each.

In the External Radio screen on the left click the Track button.

Click OK and you'll return to the SDR Console screen.

On the left, you will probably want to check Power on When Program Starts and Restore 'Track' state on power on. Make sure that ALL tracking boxes on the right of that window are checked.

You're back to the External Radio settings.

at a MAX of 100 (may not allow you to go lower), and timeout ms.

Use these settings: TS-2000 (REGARDLESS of what your transceiver is), the SECOND com port of the virtual pair you created in VSPM, in my case COM11, baud rate 57600, data bits 8, parity None, stop bits 1, RTS and DTR both set to low, poll int.

Click on the 'Omnirig Settings' box and a dialog will appear.

Click on the question mark at the top of the External Radio interface.

When you re-run SDR Console you'll see the External Radio interface appear beneath the IF display on the left of the program.

If it's not configured SDR Console will advise you that you have to restart for it to work.

Under SDR Console's View tab click on External Radio.

If your SDR is set to automatically start that's fine as whether or not it's running during this configuration was at least to me irrelevant.

#Change the date format in ham radio deluxe install

If you haven't already, obtain and install Omnirig software.